Spotlight Manufacturing Process

Dec 08, 2025

Leave a message

1. Cleaning: Ultrasonic cleaning of the PCB or LED bracket, followed by drying.

 

2. Mounting: After applying silver paste to the bottom electrodes of the LED die (large disc), it is expanded. The expanded die (large disc) is placed on a bonding machine, and under a microscope, the die is individually mounted onto the corresponding pads on the PCB or LED bracket using a bonding pen. Sintering is then performed to cure the silver paste.

 

3. Wire Bonding: Electrodes are connected to the LED die using aluminum or gold wire bonding machines to serve as leads for current injection. For LEDs directly mounted on the PCB, aluminum wire bonding is generally used.

 

4. Encapsulation: Epoxy resin is applied to protect the LED die and bonding wires. The shape of the cured epoxy resin applied to the PCB is critical, directly affecting the brightness of the finished backlight. This process also involves applying phosphor (for white LEDs).

 

5. Soldering: If the backlight uses SMD-LEDs or other pre-packaged LEDs, the LEDs need to be soldered onto the PCB before assembly.

 

6. Film Cutting: Use a punch press to die-cut various diffusion films, reflective films, etc., required for the backlight.

 

7. Assembly: Manually install the various materials of the backlight in the correct positions according to the drawings.

 

8. Testing: Check whether the photoelectric parameters and light emission uniformity of the backlight are good.

 

9. Packaging: Pack the finished product according to requirements and put it into storage.

Send Inquiry